Piggyback Rendezvous Cannulation for Endoscopic Metal Stent Conversion of Percutaneous Transhepatic Biliary Drainage

Article information

Clin Endosc. 2018;51(2):206-207

Publication date (electronic) : 2017 October 11

doi : https://doi.org/10.5946/ce.2017.110

Vincent Zimmer^,1,2

¹Department of Medicine, Marienhausklinik St. Josef Kohlhof, Neunkirchen, Germany

²Department of Medicine II, Saarland University Medical Center, Saarland University Homburg, Homburg, Germany

Correspondence: Vincent Zimmer Department of Medicine, Marienhausklinik St. Josef Kohlhof, Klinikweg 1-5, Neunkirchen 66539, Germany Tel: +49-6821-3632070, Fax: +49-6821-3632624, E-mail: vincent.zimmer@gmx.de

Received 2017 July 7; Revised 2017 August 18; Accepted 2017 September 13.

Biliary rendezvous procedures typically imply over-the-wire cannulation after guidewire insertion via a percutaneous transhepatic biliary drainage (PTBD). Alternative techniques, such as the parallel cannulation method alongside the PTBD catheter have been reported [1]. More recently, other escape techniques that substitute guidewires for different interventional radiology (IR) catheters have been described, such as angiography Cobra 2 and Kumpe access catheter, with the aim at retrograde cannulation after establishing appropriate end-to-end contact [2,3]. However, these techniques require specialized IR accessories and/or competence. This report introduces another easy-to-perform variant technique for rendezvous procedures that resort to ubiquitously available endoscopy technology and minimal need for external (rendezvous) cooperation.

As the first step of the procedure, the indwelling 10-F internal-external PTBD drain is withdrawn under duodenoscopic control up to the papilla. Following this, the tip of a 5.5-F endoscopic retrograde cholangiopancreatography (ERCP) catheter, with a conical metal tip, is pushed into the orifice of the PTBD drain until achieving proper alignment. Subsequently, the common bile duct stricture is traversed in a piggyback fashion using coordinated pull (PTBD) and push (ERCP catheter) maneuvers. After releasing the end-to-end contact, the PTBD is withdrawn into the intrahepatic biliary system (provisionally left in place until the procedure is finished). In the elderly, frail patient depicted in the figure and video, after cannulation of the route with guidewire insertion, a 10- × 60-mm transpapillary biliary metal stent was placed for definitive palliative treatment and the PTBD was removed (Fig. 1, Supplementary Video 1).

Fig. 1.

Different steps of the novel piggyback technique for rendezvous cannulation with biliary metal stent conversion. (A) Cannulation of the withdrawn 10-F percutaneous transhepatic biliary drainage (PTBD) catheter with a conical, tapered-tip, 5.5-F endoscopic retrograde cholangiopancreatography (ERCP) catheter (Endoflex, Voerde, Germany). (B) Pushing of the cannula into the intern-extern drain for proper alignment (note spraining of the PTBD catheter). (C) Crossing of the common bile duct stricture using coordinated push (ERCP) and pull (PTBD catheter) maneuvers. (D) Removal of the ERCP cannula after guidewire insertion (0.035-inch Jagwire; Boston Scientific, Ratingen, Germany) and release of the end-to-end contact. (E) Final documentation of the transpapillary inserted, partially covered biliary metal stent (Leufen Medical, Aachen, Germany) after PTBD removal.

The potential benefits of the presented “piggyback rendezvous cannulation” technique include minimal need for percutaneous cooperation, thus obviating the need for a second endoscopist with specialized training and/or IR cooperation. Given the predominant endoscopic part of the rendezvous with minimal PTBD manipulation, other potential benefits may be discussed, such as reduced patient and staff radiation exposure, and time and equipment consumptions.